Coverage approx. 12m2 per litre per coat. A minimum of 2 coats recommended.

How to Apply Paint to Trim by Brush:

• Stir thoroughly before use.
• By ‘trim’ we mean: skirting boards, picture rails, dado rails, doors, door frames and architraves, interior window sills and window frames (providing they aren’t plastic).
• Farrow & Ball paints are water borne, and unlike solvent borne paints, water borne paint is more resistant to sagging and you will achieve the best finish by painting a thicker coat.
• For best results use a quality fine-tipped synthetic bristled paint brush.
•  Load the brush well and apply a generous first coat. Brushing first in a vertical direction then in a horizontal direction until an even coating has been applied.
• Finish by 'laying off' the paint in one direction using light pressure, with the brush held at an angle of approximately 30°.
• Do not “overwork” the paint or attempt to brush it out in thin even coats as you would a traditional solvent borne paint as this may create excess brush marks.
• Allow to dry completely (for a minimum of 4 hours) before applying a second coat following the same technique as before.

How to Apply Paint to Trim by Roller:

• Stir thoroughly before use.
• By ‘trim’ we mean: skirting boards, picture rails, dado rails, doors, door frames and architraves, interior window sills and window frames (providing they aren’t plastic).
• This paint finish can also be applied using a Medium Pile Woven Polyester Roller. This will provide a good finish with minimal stippling and is a quick method of application. However, where an optimum finish is required, we would recommend brush application using a fine-tipped, synthetic bristled brush.

How to Apply Paint to Walls by Brush:

• Stir thoroughly before use.
• Ensure all surfaces are sound, clean, dry and free from dirt, grease and other contamination.
• Please note that flaking or peeling may occur if you paint over weak paint layers - to avoid this sand back any previous weak paint layers before you start painting.
• Where required apply Farrow & Ball Wall & Ceiling Primer & Undercoat to improve paint adhesion and promote depth of colour.
• Using a fine-tipped synthetic bristled brush, apply the paint in a vertical direction then spread the paint out evenly in a horizontal direction.
• On application of the final coat lay off the paint in a single direction to ensure that any brush marks and brush patterning effects (sometimes visible in certain lighting conditions) are minimised.

How to Apply Paint to Walls by Roller:

• Stir thoroughly before use.
• Using a medium pile woven polyester roller, apply the paint in diagonal strokes to create either an ‘M’, ‘W’ or ‘V’ shape.
• Fill in and over the shape you have just painted to spread the paint evenly.
• Repeat this process, working in small sections.
• Always work from dry to wet areas, maintaining a wet edge to minimise roller marks.
• On application of the final coat lay off the paint in a single direction to ensure that any roller patterning effects (sometimes visible in certain lighting conditions) are minimised.

Clean brushes, rollers and equipment with warm soapy water. 

This product is water based and must be protected from frost and extreme temperatures. Use within 6 months of purchase. We accept no responsibility for the deterioration of contents or packaging after this date.

Do not empty into drains or watercourses. Dispose of contents/container to waste disposal site in accordance with local/national regulations. Contact the local Environmental Department for disposal instructions. Metal containers may be recycled. 

• Highly Durable
• Waterbased and quick drying
• Eco friendly
• Child safe
• Washble and wipeable
• Scuff and stain resistant