Coverage is variable to surface and conditions. 

Professional applicators experienced in applying limewash should be employed.

• Stir thoroughly before use.
• Lime renders can vary dramatically in porosity, leading to patching, this is more pronounced when using darker colours. Therefore Limewash requires a minimum of three coats to build up opacity and even out irregularities in tone.
• When using Farrow & Ball Exterior Masonry and Farrow & Ball Limewash on the same property, there will be a noticeable difference in both texture and colour.
• Do not apply Limewash in very damp or wet, windy conditions, direct sunlight, or if there is danger of frost for several weeks after the Limewash has been applied.
• Dilution: Dilute the Limewash with water to suit site conditions. This would typically be between 10 – 30% but could be up to 100% depending on the surface being painted.
• Please note that colours in Limewash vary according to the surface they are applied to. Certain colours may appear up to 10 shades darker when wet.
• Please check you have the right colour prior to use as we will not be liable for decorating costs caused as a result of an incorrect colour being applied.
• When more than one tin of the same colour is to be used ensure that batch numbers are identical or intermix before use.
• Stir well before and often during application.
• Dampening down is very important for a good finish. Only spray with water an area of approximately 3m² at a time until the surface is damp but not running with water.
• Limewash should only be applied to a freshly dampened surface. Limewash should never be applied to a dry surface, as this will cause rapid drying out of the Limewash and result in dusting.
• Old Limewash, cob, and lime plaster will need more dampening down than harder surfaces.
• The Limewash should be applied in several thin coats. Apply with a long haired or masonry paintbrush.
• Ensure the Limewash is applied as evenly as possible and is well worked into any cracks and joins, but not allowing it to build up too thickly at any point or it will craze on drying out.
• Avoid losing a wet edge as you move to the next area, damping as you go.
• For subsequent coats allow the previous coat to dry out completely, preferably overnight. Lightly dampen down with water the previous coat before applying the next.
• A minimum of three coats should be applied; more on new external surfaces or when changing colour.
• After the initial drying out, Limewash will continue to harden and strengthen for several weeks.
• Newly lime plastered surfaces should be fully carbonated and cured for 4-5 weeks prior to application.

Considerations: Due to the traditional nature of this finish, Farrow & Ball Limewash will not accept subsequent layers of modern paints.

Clean brushes and equipment with clean warm soapy water and rinse thoroughly afterwards. Please ensure skin and eyes are protected from splashing. 

This product is water based and must be protected from frost and extreme temperatures. Use within 6 months of purchase. We accept no responsibility for the deterioration of contents or packaging after this date. 

Do not empty into drains or watercourses. Dispose of contents/container to waste disposal site in accordance with local/national regulations. Contact the local Environmental Department for disposal instructions. Metal containers may be recycled. 

• Very flat finish - 2% sheen level
• Waterbased and quick drying
• Highly breathable
• Eco friendly
• Low odour